TransPort WR44 R Configuration

Vehicle Installation

Plug your TransPort WR44 R device into your vehicle's OBDII bus connector. This connector is available on all vehicles built and sold in the US after January 1996, and is generally located and exposed within 3 feet of the driver, typically under the dash. This connector will typically look similar to the following:

Once you've connected your TransPort WR44 R device to your vehicle's OBDII bus connector, the LEDs on your device will go through an initialization process. At the end of this process your LEDs should appear as follows:

• POWER LED (front surface of the TransPort WR44 R) should be green

Note: See the Troubleshooting section for complete LED functionality.

You've completed the process of configuring your device to communicate with MAP. Proceed to Step 3 where you'll register your mobile tracker device with MAP.

Back to Step 2 | Move to Step 3